Dynamic responses of metal foam sandwich beams to repeated impacts
-
摘要: 为了研究重复冲击载荷作用下泡沫金属夹芯梁的动态响应，采用Abaqus数值仿真软件，基于可压碎泡沫模型（crushable foam），建立了泡沫金属夹芯梁遭受楔形质量块冲击的有限元模型。通过将仿真获得的夹芯梁上下面板最终挠度与重复冲击实验结果进行对比，验证仿真方法的准确性。在此基础之上，分析了泡沫金属夹芯梁在楔形质量块重复冲击作用下的变形模式、加卸载过程以及能量耗散特性。结果表明，在重复冲击载荷作用下，夹芯梁的变形不断累积，上面板主要出现局部凹陷和整体弯曲，而芯层则是局部压缩，下面板表现为整体弯曲。在重复加卸载过程中，加卸载刚度随着冲击次数的增加而增大。随着冲击次数的增加，上面板和芯层的能量吸收增量不断减小，而下面板的能量吸收增量不断增加，且最终均趋于稳定。泡沫金属夹芯梁的塑性变形能增量不断减小，而回弹系数随着冲击次数逐渐增加，最后趋于稳定值。Abstract: The phenomena of repeated impacts are very common, especial in the field of ship and ocean engineering. When the ship structures suffering from repeated impact loadings, the deformation and damages will accumulate, leading to failure even damage of the structures, which may cause serious accident. In order to study the dynamic behaviors of metal foam sandwich beams (MFSBs) under repeated impact loadings, the nonlinear finite element model was established based on the material model of crushable foam by using Abaqus-Explicit, and the approach to achieve repeated impacts in the software was proposed. The accuracy of the numerical simulation was verified by comparing the permanent deflections of front and back face sheets. Based on the results of the numerical simulations, the deformation modes, loading and unloading process as well as the energy absorption behavior of the MFSBs under repeated impacts were analyzed. Results show that during repeated impacts, the deformation of the MFSBs is accumulated gradually, the front face sheet mainly experiences global bending and local indentation, and the metal foam core suffers from local compression, while the back face sheet is subjected to global bending. During the repeated impacts, the loading and unloading stiffness increases with the impact number. The energy absorption of front face is larger than that of back face and metal foam core in all the impacts. As the impact number increases, the energy absorbed by front face sheet and foam core declines gradually, while that of the back face sheet increases, approaching a constant value. The plastic deformation energy of the MFSBs decreases with the impact number, on the opposite, the rebound energy of the MFSBs increases gradually with the impact number, while both of them trends to be stable. The proposed finite element method can be applied to accurately predict the dynamic responses of the MFSBs suffering from repeated impact loadings, and provide technical supports for the anti-impact design of metal foam sandwich structures.
-
图 1 低碳钢和泡沫铝的塑性应力应变曲线
Figure 1. Plastic stress-strain curves of mild steel and aluminum foam
图 4 不同冲击次数时夹芯梁最终变形对比
Figure 4. Comparison of permanent deflections in different impact numbers
图 6 最终挠度的数值仿真结果与实验结果的对比
Figure 6. Comparison of permanent deflections between numerical simulation and impact test
图 7 夹芯梁重复冲击变形过程
Figure 7. Deformation process of the sandwich beam under repeated impacts
图 9 夹芯梁上、下面板中点挠度时程曲线
Figure 9. Time histories of deflections of the front and back faces of the sandwich beam
图 11 泡沫金属夹芯梁各部分的变形能时程曲线
Figure 11. Time histories of energy absorption for different parts of the metal foam sandwich beam
图 12 不同冲击次数下夹芯梁各部分的能量吸收
Figure 12. Energy absorption for different parts of the metal foam sandwich beam at different impact numbers
图 14 不同冲击次数下的能量吸收效率
Figure 14. Energy absorption efficiency at different impact numbers
-
[1] ZHU L. Dynamic inelastic behaviour of ship plates in collision [D]. Glasgow: University of Glasgow, 1990: 45−56. [2] ZHU L. Faulkner D. Damage estimate for plating of ships and platforms under repeated impacts [J]. Marine Structures, 1996, 9(9): 697–720. DOI: 10.1016/0951-8339(95)00018-6. [3] ZHU L, CAI W, CHEN M S, et al. Dynamic analysis of ship plates under repeated ice floes impacts based on a simplified ship-ice collision model [C]//Proceedings of the 28th International Ocean and Polar Engineering Conference. Sapporo, Japan: International Society of Offshore and Polar Engineers, 2018: 1718−1723. [4] ZHU L, SHI S Y, JONES N. Dynamic response of stiffened plates under repeated impacts [J]. International Journal of Impact Engineering, 2018, 117: 113–122. DOI: 10.1016/j.ijimpeng.2018.03.006. [5] 杨宝, 汤立群, 刘逸平, 等. 冲击条件下泡沫铝的细观变形特征分析 [J]. 爆炸与冲击, 2012, 32(4): 399–403. DOI: 10.11883/1001-1455(2012)04-0399-05.YANG B, TANG L Q, LIU Y P, et al. Meso deformation characteristics analysis of aluminum foam under impact [J]. Explosion and Shock Waves, 2012, 32(4): 399–403. DOI: 10.11883/1001-1455(2012)04-0399-05. [6] 王鹏飞, 徐松林, 李志斌, 等. 高温下轻质泡沫铝动态力学性能实验 [J]. 爆炸与冲击, 2014, 34(4): 433–438. DOI: 10.11883/1001-1455(2014)04-0433-06.WANG P F, XU S L, LI Z B, et al. An experimental study on dynamic mechanical property of ultra-light aluminum foam under high temperatures [J]. Explosion and Shock Waves, 2014, 34(4): 433–438. DOI: 10.11883/1001-1455(2014)04-0433-06. [7] YU J L, WANG X, WEI Z G, et al. Deformation and failure mechanism of dynamically loaded sandwich beams with aluminum-foam core [J]. International Journal of Impact Engineering, 2003, 28(3): 331–347. DOI: 10.1016/S0734-743X(02)00053-2. [8] YU J L, WANG E H, LI J R, et al. Static and low-velocity impact behavior of sandwich beams with closed-cell aluminum-foam core in three-point bending [J]. International Journal of Impact Engineering, 2008, 35(8): 885–894. DOI: 10.1016/j.ijimpeng.2008.01.006. [9] TAN Z H, LUO H H, LONG W G, et al. Dynamic response of clamped sandwich beam with aluminum alloy foam core subjected to impact loading [J]. Composites Part B: Engineering, 2013, 46: 39–45. DOI: 10.1016/j.compositesb.2012.10.044. [10] 敬霖, 王志华, 赵隆茂, 等. 撞击载荷下泡沫铝夹芯梁的塑性动力响应 [J]. 爆炸与冲击, 2010, 30(6): 561–568. DOI: 10.11883/1001-1455(2010)06-0561-08.JING L, WANG Z H, ZHAO L M, et al. Dynamic plastic response of foam sandwich beams subjected to impact loading [J]. Explosion and Shock Waves, 2010, 30(6): 561–568. DOI: 10.11883/1001-1455(2010)06-0561-08. [11] JING L, WANG Z H, NING J G, et al. The dynamic response of sandwich beams with open-cell metal foam cores [J]. Composites Part B: Engineering, 2011, 42(1): 1–10. DOI: 10.1016/j.compositesb.2010.09.024. [12] DESHPANDE V S, FLECK N A. Isotropic constitutive models for metallic foams [J]. Journal of the Mechanics and Physics of Solids, 2000, 48(6−7): 1253–1283. DOI: 10.1016/S0022-5096(99)00082-4. [13] QIU X M, DESHPANDE V S, FLECK N A. Finite element analysis of the dynamic response of clamped sandwich beams subject to shock loading [J]. European Journal of Mechanics: A/Solids, 2003, 22(6): 801–814. DOI: 10.1016/j.euromechsol.2003.09.002. [14] TILBROOK M T, DESHPANDE V S, FLECK N A. Underwater blast loading of sandwich beams: regimes of behaviour [J]. International Journal of Solids and Structures, 2009, 46(17): 3209–3221. DOI: 10.1016/j.ijsolstr.2009.04.012. [15] JING L, SU X Y, CHEN D, et al. Experimental and numerical study of sandwich beams with layered-gradient foam cores under low-velocity impact [J]. Thin-Walled Structures, 2019, 135: 227–244. DOI: 10.1016/j.tws.2018.11.011. [16] QIU X M, DESHPANDE V S, FLECK N A. Impulsive loading of clamped monolithic and sandwich beams over a central patch [J]. Journal of the Mechanics and Physics of Solids, 2005, 53(5): 1015–1046. DOI: 10.1016/j.jmps.2004.12.004. [17] QIN Q H, WANG T J. Low-velocity heavy-mass impact response of slender metal foam core sandwich beam [J]. Composite Structures, 2011, 93(6): 1526–1537. DOI: 10.1016/j.compstruct.2010.11.018. [18] QIN Q H, WANG T J. Low-velocity impact response of fully clamped metal foam core sandwich beam incorporating local denting effect [J]. Composite Structures, 2013, 96: 346–356. DOI: 10.1016/j.compstruct.2012.09.024. -
下载:
计量
- 文章访问数: 936
- HTML全文浏览量: 349
- PDF下载量: 212
- 被引次数: 0