A simple method of measuring impulse current of small high-voltage exploding device

Chen Yi; Yuan Shi-wei; Wu Hao; Wang Peng; Lin Run-shan

doi:10.11883/1001-1455(2015)01-0065-05

Volume 35 Issue 1

Feb. 2015

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > Explosion And Shock Waves > 2015 > 35(1): 65-69

GONG Bai-lin, LU Fang-yun, LI Xiang-yu. Atheoreticalmodelforforecastingdeformationshapesofdeformablewarheads[J]. Explosion And Shock Waves, 2010, 30(1): 65-69. doi: 10.11883/1001-1455(2010)01-0065-05

Citation:

Chen Yi, Yuan Shi-wei, Wu Hao, Wang Peng, Lin Run-shan. A simple method of measuring impulse current of small high-voltage exploding device[J]. Explosion And Shock Waves, 2015, 35(1): 65-69. doi: 10.11883/1001-1455(2015)01-0065-05

GONG Bai-lin, LU Fang-yun, LI Xiang-yu. Atheoreticalmodelforforecastingdeformationshapesofdeformablewarheads[J]. Explosion And Shock Waves, 2010, 30(1): 65-69. doi: 10.11883/1001-1455(2010)01-0065-05

Citation:

PDF( 712 KB)

A simple method of measuring impulse current of small high-voltage exploding device

doi: 10.11883/1001-1455(2015)01-0065-05

School of Astronautics, BeiHang University, Beijing 100191, China

Received Date: 2013-05-02
Rev Recd Date: 2013-07-15
Publish Date: 2015-01-25

Abstract

Abstract

A simple method was developed for measuring the impulse current waveform produce by a small high-voltage exploding device. The model of impulse current was determined by attenuation coefficient. To estimate the attenuation coefficient from the actual discharge voltage curve, the Levenberg-Marquarat algorithm was applied based on the equivalent circuit of discharge circuit and its differential equations. Compared with the direct measuring methods such as using shunt or Rogowski coil, this method overcomes the distortion of impulse current waveform caused by additional measuring circuit. The results show that the simulation current waveform fits the actual current waveform well. The method can be used for optimum matching design of electronic safety, arming device of in-line fuse or low-energy slapper detonator.
- mechanics of explosion,
- Levenberg-Marquarat algorithm,
- impulse current simulation,
- small high-voltage exploding device,
- attenuation coefficient

FullText(HTML)

References(8)

References

[1]	陈景亮, 姚学玲, 孙伟.脉冲电流技术[M].西安: 西安交通大学出版社, 2008.
[2]	戴建华, 李开成.基于Rogowski线圈的大电流测量[J].高电压技术, 2002, 28(1): 6-10. Dai Jian-hua, Li Kai-cheng. Heavy current measurement based on Rogowski coil[J]. High Voltage Engineering, 2002, 28(1): 6-10.
[3]	Eriksson J, Wedin P A, Gulliksson M E. Regularization methods for uniformly rank-deficient nonlinear least-squares problems[J]. Journal of Optimization Theory and Applications, 2005, 127(1): 1-26. doi: 10.1007%2Fs10957-005-6389-0
[4]	Zhang J Z, Xue Y, Zhang K. A structured secant method based on a new quasi-newton equation for nonlinear least squares problems[J]. Bit Numerical Mathematics, 2003, 43(1): 217-229. doi: 10.1023/A:1023665409152
[5]	邹志伟.求解对称非线性方程组的一种修正共轭梯度法[D].长沙: 湖南大学, 2010.
[6]	孙风建.基于新拟牛顿方程的非线性最小二乘的一类新算法[D].南京: 南京理工大学, 2007.
[7]	Fan Jin-yan. The modified Levenberg-Marquardt method for nonlinear equations with cubic convergence[J]. Mathematics of Computation, 2011, 81(277): 447-466.
[8]	王新洲.非线性模型参数估计理论与应用[M].武汉: 武汉大学出版社, 2002.

Relative Articles

[1]	WU Shuogang, DU Chengxin, ZHOU Feng, GAO Guangfa, LYU Wenzheng, CHEN Xi. Damage characteristic of target penetrated by WF/Zr-MG and 93W rods[J]. Explosion And Shock Waves, 2024, 44(4): 043302. doi: 10.11883/bzycj-2023-0312
[2]	WANG Yang, LI Guangbin, WANG Guiji, TANG Enling, GAO Guowen, PENG Hui. A study of anti-penetration properties of continuous fiber-reinforced high-porosity composites[J]. Explosion And Shock Waves, 2024, 44(10): 101401. doi: 10.11883/bzycj-2023-0472
[3]	LIU Muhao, ZHANG Xianfeng, TAN Mengting, BAO Kuo, HAN Guoqing, LI Yi, SUN Weijing. A constitutive model for ceramic materials including microstructural features and damage factor[J]. Explosion And Shock Waves, 2024, 44(1): 013102. doi: 10.11883/bzycj-2023-0237
[4]	WANG Min, WEN Heming. Numerical simulations of response and failure of carbon nanotube/carbon fibre reinforced plastic laminates under impact loading[J]. Explosion And Shock Waves, 2022, 42(3): 033102. doi: 10.11883/bzycj-2021-0050
[5]	ZHENG Zhihao, REN Huiqi, LONG Zhilin, GUO Ruiqi, CAI Yang, LI Zhijian. A study on impact compression mechanical properties of PP/CF reinforced coral sand cement-based composites[J]. Explosion And Shock Waves, 2022, 42(7): 073104. doi: 10.11883/bzycj-2021-0297
[6]	ZHOU Zhixuan, WANG Mafa, LI Junling, MA Zhaoxia. Crater characteristics of carbon fiber/epoxy composite under hypervelocity impact in the velocity range from 3.0 km/s to 6.5 km/s[J]. Explosion And Shock Waves, 2022, 42(8): 083301. doi: 10.11883/bzycj-2021-0251
[7]	ZHANG Na, ZHOU Jian, XU Mingfeng, LI Hui, MA Guowei. Dynamic mechanical properties of basalt fiber engineered cementitious composites[J]. Explosion And Shock Waves, 2020, 40(5): 053101. doi: 10.11883/bzycj-2019-0351
[8]	CHEN Jianliang, LI Jicheng. Ballistic behavior of tungsten fiber/metallic glass matrix composite segmented rods[J]. Explosion And Shock Waves, 2020, 40(6): 063201. doi: 10.11883/bzycj-2019-0379
[9]	CHENG Yihao, DENG Guoqiang, LI Gan, SONG Chunming, QIU Yanyu, ZHANG Zhongwei, WANG Derong, WANG Mingyang. Model experiments on penetration of layered geological material targets by hypervelocity rob projectiles[J]. Explosion And Shock Waves, 2019, 39(7): 073301. doi: 10.11883/bzycj-2018-0230
[10]	Wang Jiagang, Yu Yonggang, Zhou Liangliang, Cao Hanxue, Liu Xi. Fracture analysis of glass fiber reinforced composite material under high temperature and pressure[J]. Explosion And Shock Waves, 2017, 37(6): 1107-1112. doi: 10.11883/1001-1455(2017)06-1107-06
[11]	Xu Ying, Shao Binbin, Xu Weiwei, Yang Jianming. Dynamic splitting tensile test of short carbon fiber C/SiC ceramic matrix composites[J]. Explosion And Shock Waves, 2017, 37(2): 315-322. doi: 10.11883/1001-1455(2017)02-0315-08
[12]	Hou Hai-zhou, Hu Yi-ting, Peng Jin-hua, Jin Jian-wei. Dynamic behavior and constitutive model of phenolic cotton fabric material under impact loading[J]. Explosion And Shock Waves, 2015, 35(6): 858-863. doi: 10.11883/1001-1455(2015)06-0858-06
[13]	CHEN Xiao-wei, LI Ji-cheng, ZHANG Fang-ju, CHEN Gang. Experimentalresearchonthepenetrationoftungsten-fiber/metallic glass-matrixcompositematerialpenetratorintosteeltarge[J]. Explosion And Shock Waves, 2012, 32(4): 346-354. doi: 10.11883/1001-1455(2012)04-0346-09
[14]	HUANG Xia, TANG Wen-hui, JIANG Bang-hai. Influencesofconstitutivemodelsonnumericallysimulatedresultsof X-raythermalshockwavesincompositematerials[J]. Explosion And Shock Waves, 2011, 31(6): 600-605. doi: 10.11883/1001-1455(2011)06-0600-06
[15]	LIU Ying, HE Zhang-quan, WU He-xiang, ZHANG Xin-chun. In-planedynamiccrushingoffunctionallylayeredmetalhoneycombs[J]. Explosion And Shock Waves, 2011, 31(3): 225-331. doi: 10.11883/1001-1455(2011)03-0225-07
[16]	LIU Hai-feng, NING Jian-guo. A meso-mechanical constitutive model of concrete subjected to impact loading[J]. Explosion And Shock Waves, 2009, 29(3): 261-267. doi: 10.11883/1001-1455(2009)03-0261-07
[17]	SHANG Bing, SHENG Jing, WANG Bao-zhen, HU Shi-sheng. Dynamic mechanical behavior and constitutive model of stainless steel[J]. Explosion And Shock Waves, 2008, 28(6): 527-531. doi: 10.11883/1001-1455(2008)06-0527-05
[18]	LIU Ming-shuang, LI Yu-long, TAO Liang, XU Fei, CHENG Lai-fei. A strain-rate-dependent dynamic constitutive model of 2D-C/SiC composites[J]. Explosion And Shock Waves, 2008, 28(5): 421-426. doi: 10.11883/1001-1455(2008)05-0421-06
[19]	JIANG Bang-hai, ZHANG Ruo-qi. Strain rate-dependent Tsai-Hill strength criteria for a carbon fiber woven reinforced composite[J]. Explosion And Shock Waves, 2006, 26(4): 333-338. doi: 10.11883/1001-1455(2006)04-0333-06

Supplements(0)

Cited By

Cited by

Periodical cited type(4)

1.	张琦，桂劲松. 基于粘结单元的空心钢管桩沉桩过程数值模拟. 珠江水运. 2023(12): 99-101 .
2.	王敏，文鹤鸣. 碳纳米管/碳纤维增强复合材料层合板低速冲击响应和破坏的数值模拟. 爆炸与冲击. 2022(03): 25-36 . 本站查看
3.	马玉秋，郭策，陈光明，戴宁，管吉钢，何湘鹏. 仿生轻质高强韧夹芯结构设计及其韧性性能分析. 机械科学与技术. 2022(05): 801-807 .
4.	马桢，吴伟，高志雄，王涛，张柱，常超. 弹道冲击下钛/钢复合波纹板的界面力学研究. 重庆理工大学学报(自然科学). 2021(07): 108-114 .