Measurement of strength in a Zr-based bulk metallic glass under dynamic high-pressure loading

Yu Yu-ying; Xi Feng; Dai Cheng-da; Cai Ling-cang; Tan Hua; Li Xue-mei

Volume 34 Issue 1

Mar. 2014

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > Explosion And Shock Waves > 2014 > 34(1): 1-5

ZHANG Xuan, YU Yonggang, ZHANG Xinwei. Analysis of muzzle flow field characteristics of gun fired in different media[J]. Explosion And Shock Waves, 2021, 41(10): 103901. doi: 10.11883/bzycj-2021-0056

Citation:

Yu Yu-ying, Xi Feng, Dai Cheng-da, Cai Ling-cang, Tan Hua, Li Xue-mei. Measurement of strength in a Zr-based bulk metallic glass under dynamic high-pressure loading[J]. Explosion And Shock Waves, 2014, 34(1): 1-5.

ZHANG Xuan, YU Yonggang, ZHANG Xinwei. Analysis of muzzle flow field characteristics of gun fired in different media[J]. Explosion And Shock Waves, 2021, 41(10): 103901. doi: 10.11883/bzycj-2021-0056

Citation:

PDF( 1073 KB)

Measurement of strength in a Zr-based bulk metallic glass under dynamic high-pressure loading

National Key Laboratory of Shock Wave and Detonation Physics, Institute of Fluid Physics, China Academy of Engineering Physics, Mianyang 621999, Sichuan, China

Funds: Supported by the National Natural Science Foundation of China (10732010, 10972206, 11172281)

Received Date: 2012-07-25
Rev Recd Date: 2013-01-01
Publish Date: 2014-01-25

Abstract

Abstract

To investigate the dynamic strength behaviors of a Zr-based bulk metallic glass(BMG), Zr51Ti5Ni10Cu25Al9(in atomic percent), a series of reverse-impact experiments were performed in the peak shock stress range from 37to 66GPa.A displacement interferometer system for any reflector(DISAR)was used to measure the particle velocity profiles at the sample/LiF window interface.By analyzing the measured particle velocity profiles, the yield strength and shear modulus of the Zr-based BMG were obtained.The experimental results show that both the yield strength and the shear modulus of the Zr-based BMG increase with the increasing of the shock stresses in the stress range considered here.And the shear stress relaxation across the shock wave front of the Zr-based BMG is not due to the shock-induced damage/failure or temperature softening.
- solid mechanics,
- yield strength,
- DISAR,
- bulk metallic glass,
- shear modulus,
- shock wave

FullText(HTML)

References(19)

References

[1]	Inoue A. Stabilization of metallic supercooled liquid and bulk amorphous alloys[J]. Acta Materialia, 2000, 48(1): 279-306. doi: 10.1016/S1359-6454(99)00300-6
[2]	Schuh C A, Hufnagel T C, Ramamurty U. Mechanical behavior of amorphous alloys[J]. Acta Materialia, 2007, 55(12): 4067-4109. doi: 10.1016/j.actamat.2007.01.052
[3]	Trexler M M, Thadhani N N. Mechanical properties of bulk metallic glasses[J]. Progress in Materials Science, 2010, 55(8): 759-839. doi: 10.1016/j.pmatsci.2010.04.002
[4]	Lu J, Ravichandran G. Pressure-dependent flow behavior of Zr_41.2Ti_13.8Cu_12.5Ni₁₀Be_22.5 bulk metallic glass[J]. Journal of Materials Research, 2003, 18(9): 2039-2049. doi: 10.1557/JMR.2003.0287
[5]	Mashimo T, Togo H, Zhang Y, et al. Hugoniot-compression curve of a Zr-based bulk metallic glass[J]. Applied Physics Letters, 2006, 89(24): 241904. doi: 10.1063/1.2403931
[6]	Xi F, Yu Y Y, Dai C D, et al. Shock compression response of a Zr-based bulk metallic glass up to 110GPa[J]. Journal of Applied Physics, 2010, 108(8): 083537. doi: 10.1063/1.3501044
[7]	Turneaure S J, Dwivedi S K, Gupta Y M. Shock-wave induced tension and spall in a zirconium-based bulk amorphous alloy[J]. Journal of Applied Physics, 2007, 101(4): 043514. doi: 10.1063/1.2537982
[8]	Yuan F P, Prakash V, Lewandowski J J. Spall strength and Hugoniot elastic limit of a zirconium-based bulk metallic glass under planar shock compression[J]. Journal of Materials Research, 2007, 22(2): 402-411. doi: 10.1557/jmr.2007.0053
[9]	Yuan F P, Prakash V, Lewandowski J J. Shear yield and flow behavior of a zirconium-based bulk metallic glass[J]. Mechanics of Materials, 2010, 42(3): 248-255. doi: 10.1016/j.mechmat.2009.11.003
[10]	Turneaure S J, Winey J M, Gupta Y M. Response of a Zr-based bulk amorphous alloy to shock wave compression[J]. Journal of Applied Physics, 2006, 100(6): 063522. doi: 10.1063/1.2345606
[11]	俞宇颖, 习锋, 戴诚达, 等.冲击加载下Zr₅₁Ti₅Ni₁₀Cu₂₅Al₉金属玻璃的塑性行为[J].物理学报, 2012, 61(19): 196202. doi: 10.7498/aps.61.196202 Yu Yu-ying, Xi Feng, Dai Cheng-da, et al. Plastic behavior of Zr₅₁Ti₅Ni₁₀Cu₂₅Al₉ metallic glass under planar shock loading[J]. Acta Physica Sinica, 2012, 61(19): 196202. doi: 10.7498/aps.61.196202
[12]	Arman B, Luo S N, Germann T C, et al. Dynamic response of Cu₄₆Zr₅₄ metallic glass to high-strain-rate shock loading: Plasticity, sapll and atomic-level structures[J]. Physical Review B, 2010, 81(14): 144201. doi: 10.1103/PhysRevB.81.144201
[13]	Wang W H, Li F Y, Pan M X, et al. Elastic property and its response to pressure in a typical bulk metallic glass[J]. Acta Materialia, 2004, 52(3): 715-719. doi: 10.1016/j.actamat.2003.10.008
[14]	Weng J D, Tan H, Wang X, et al. Optical-fiber interferometer for velocity measurements with picosecond resolution[J]. Applied Physics Letters, 2006, 89(1): 111101. doi: 10.1063/1.2335948
[15]	Narsh S P. LASL Shock Hugoniot Data[M]. Berkeley: University of California Press, 1980: 296-297.
[16]	谭华.实验冲击波物理导引[M].北京: 国防工业出版社, 2007: 163-167.
[17]	Yu Y Y, Tan H, Hu J B, et al. Determination of effective shear modulus of shock-compressed LY12Al from particle velocity profile measurements[J]. Journal of Applied Physics, 2008, 103(10): 103529. doi: 10.1063/1.2927492
[18]	Asay J R, Chhabildas L C. Determination of the shear strength of shock compressed 6061-T6aluminum[C]//Meyers M M, Murr L E. Shock waves and high-strain-rate phenomena in metals. New York: Plenum, 1981: 417-431.
[19]	Wang J G, Zhao D Q, Pan M X, et al. Correlation between onset of yielding and free volume in metallic glasses[J]. Scripta Materialia, 2010, 62(7): 477-480. doi: 10.1016/j.scriptamat.2009.12.015

Relative Articles

Supplements(0)

Cited By

Cited by

Periodical cited type(7)

1.	胡可镇，卓长飞，纪元，蒋显松. 武装直升机机载空地导弹发射过程燃气冲击效应研究. 兵工自动化. 2025(01): 82-89 .
2.	康越，马天，王俊龙，张逸之，张文博，韩笑，栗志杰. 不同海拔高度炮口冲击波动态演化特性数值模拟研究. 爆炸与冲击. 2024(12): 57-73 . 本站查看
3.	柏雯斌，余永刚，张欣尉. 水下火炮气幕式发射膛口流场演化特性的数值分析. 兵工学报. 2024(12): 4383-4394 .
4.	纪元，卓长飞，孙皓天，蒋显松，蔡雨娇. 极端载弹下直升机载火箭发射燃气冲击效应研究. 兵工自动化. 2023(02): 75-82 .
5.	廖国柔，马国鹭，张浩，陈万华，宗建宇，李中杨. 一级气体炮制退器的流场分析及其效率测试. 高压物理学报. 2023(02): 24-31 .
6.	刘越，赵子杰，戴琪，王安华，张辉. 航行体水下高膛压与高速发射载荷特性. 兵工学报. 2023(04): 1126-1138 .
7.	王雨舒，吕续舰. 水下枪炮发射问题研究综述. 装备环境工程. 2022(05): 1-13 .