Mechanical and electrical degradation of impaired batteries after impact loading

WEI Heguang; ZHOU Mingzhe; ZHU Ruiqing; HU Lingling

doi:10.11883/bzycj-2024-0312

Article Contents

Article Navigation > Explosion And Shock Waves > 2024 >

WEI Heguang, ZHOU Mingzhe, ZHU Ruiqing, HU Lingling. Mechanical and electrical degradation of impaired batteries after impact loading[J]. Explosion And Shock Waves. doi: 10.11883/bzycj-2024-0312

Citation:

WEI Heguang, ZHOU Mingzhe, ZHU Ruiqing, HU Lingling. Mechanical and electrical degradation of impaired batteries after impact loading[J]. Explosion And Shock Waves. doi: 10.11883/bzycj-2024-0312

WEI Heguang, ZHOU Mingzhe, ZHU Ruiqing, HU Lingling. Mechanical and electrical degradation of impaired batteries after impact loading[J]. Explosion And Shock Waves. doi: 10.11883/bzycj-2024-0312

Citation:

WEI Heguang, ZHOU Mingzhe, ZHU Ruiqing, HU Lingling. Mechanical and electrical degradation of impaired batteries after impact loading[J]. Explosion And Shock Waves. doi: 10.11883/bzycj-2024-0312

PDF( 4780 KB)

Mechanical and electrical degradation of impaired batteries after impact loading

doi: 10.11883/bzycj-2024-0312

WEI Heguang^1
,,
ZHOU Mingzhe^{1, 2},
ZHU Ruiqing¹,
HU Lingling^{1, 2
,
,}

1.
School of Aeronautics and Astronautics, Sun Yat-sen University, Shenzhen 518107, Guangdong, China
2.
Institute of Engineering Mechanics, Sun Yat-sen University, Guangzhou 510275, Guangdong, China

Received Date: 2024-08-28
Rev Recd Date: 2024-09-11

Available Online: 2024-09-12

Abstract

Abstract

Lithium-ion battery combustion accidents are known for their rapid onset and difficulty in extinguishment, raising significant safety concerns in environments with collision risks. These risks highlight the need for stringent damage assessment and failure prediction methods for power batteries. While severe collisions can cause immediate catastrophic damage and thermal runaway, most collisions occur at low speeds, where the impact may result in only minor external deformation without immediate failure. However, the potential safety risks associated with continued use of batteries after such minor collisions are not well understood. Current research and battery safety standards primarily focus on immediate or short-term failure after impact, leaving a gap in understanding the long-term effects of low-energy collisions on battery safety. This study addresses this gap by investigating the impact of low-energy collisions on the safety and reliability of lithium-ion batteries. A shock-compression sequential loading experiment was used to evaluate the mechanical response and failure behavior of pouch batteries under dynamic loading. The study also explored the deterioration of batteries subjected to weaker impact loads through electrochemical performance testing and internal structural damage analysis. The results reveal that even if a battery does not fail immediately under low-impact energy, its internal mechanical integrity may still be compromised, leading to a lower failure threshold under subsequent loads. Significant deterioration in capacity and internal resistance was observed, with the battery’s ability to withstand secondary loads and its electrochemical performance declining as impact energy increased. This indicates a clear correlation between impact-induced deformation and overall battery performance. The study also proposes a quantitative evaluation method for assessing the battery's condition after minor impacts, offering a valuable tool for predicting the risks associated with reusing impacted batteries. These insights are essential for understanding the response mechanisms of lithium-ion batteries under low-energy collision conditions and for optimizing safety standards for their continued use in collision-prone environments.
- lithium-ion batteries,
- impact failure,
- performance degradation,
- second load,
- impact dynamics

FullText(HTML)

References(24)

References

[1]	陈泽宇, 熊瑞, 孙逢春. 电动汽车电池安全事故分析与研究现状 [J]. 机械工程学报, 2019, 55(24): 93–104,116. DOI: 10.3901/JME.2019.24.093. CHEN Z Y, XIONG R, SUN F C. Research status and analysis for battery safety accidents in electric vehicles [J]. Journal of Mechanical Engineering, 2019, 55(24): 93–104,116. DOI: 10.3901/JME.2019.24.093.
[2]	LAI X, JIN C Y, YI W, et al. Mechanism, modeling, detection, and prevention of the internal short circuit in lithium-ion batteries: recent advances and perspectives [J]. Energy Storage Materials, 2021, 35: 470–499. DOI: 10.1016/j.ensm.2020.11.026.
[3]	周青, 夏勇, 聂冰冰, 等. 汽车碰撞安全与轻量化研发中的若干挑战性课题 [J]. 中国公路学报, 2019, 32(7): 1–14. DOI: 10.19721/j.cnki.1001-7372.2019.07.001. ZHOU Q, XIA Y, NIE B B, et al. Challenging topics in research of vehicle crash safety and lightweighting [J]. China Journal of Highway and Transport, 2019, 32(7): 1–14. DOI: 10.19721/j.cnki.1001-7372.2019.07.001.
[4]	LIU B H, JIA Y K, YUAN C H, et al. Safety issues and mechanisms of lithium-ion battery cell upon mechanical abusive loading: a review [J]. Energy Storage Materials, 2020, 24: 85–112. DOI: 10.1016/j.ensm.2019.06.036.
[5]	XU J, LIU B H, WANG L B, et al. Dynamic mechanical integrity of cylindrical lithium-ion battery cell upon crushing [J]. Engineering Failure Analysis, 2015, 53: 97–110. DOI: 10.1016/j.engfailanal.2015.03.025.
[6]	AVDEEV I, GILAKI M. Structural analysis and experimental characterization of cylindrical lithium-ion battery cells subject to lateral impact [J]. Journal of Power Sources, 2014, 271: 382–391. DOI: 10.1016/j.jpowsour.2014.08.014.
[7]	GILAKI M, AVDEEV I. Impact modeling of cylindrical lithium-ion battery cells: a heterogeneous approach [J]. Journal of Power Sources, 2016, 328: 443–451. DOI: 10.1016/j.jpowsour.2016.08.034.
[8]	KISTERS T, SAHRAEI E, WIERZBICKI T, et al. Dynamic impact tests on lithium-ion cells [J]. International Journal of Impact Engineering, 2017, 108: 205–216. DOI: 10.1016/j.ijimpeng.2017.04.025.
[9]	KERMANI G, SAHRAEI E. Dynamic impact response of lithium-ion batteries, constitutive properties and failure model [J]. RSC Advances, 2019, 9(5): 2464–2473. DOI: 10.1039/c8ra08898e.
[10]	WANG W W, YANG S, LIN C, et al. Investigation of mechanical property of cylindrical lithium-ion batteries under dynamic loadings [J]. Journal of Power Sources, 2020, 451: 227749. DOI: 10.1016/j.jpowsour.2020.227749.
[11]	LI Y D, WANG W W, LIN C, et al. A safety performance estimation model of lithium-ion batteries for electric vehicles under dynamic compression [J]. Energy, 2021, 215: 119050. DOI: 10.1016/j.energy.2020.119050.
[12]	JIA Y K, YIN S, LIU B H, et al. Unlocking the coupling mechanical-electrochemical behavior of lithium-ion battery upon dynamic mechanical loading [J]. Energy, 2019, 166: 951–960. DOI: 10.1016/j.energy.2018.10.142.
[13]	吕家慜. 基于深度调查电动汽车碰撞事故特征分析 [J]. 农业装备与车辆工程, 2022, 60(6): 105–110. DOI: 10.3969/j.issn.1673-3142.2022.06.024. LÜ J M. Analysis of characteristics of electric vehicle collision accidents based on in-depth investigation [J]. Agricultural Equipment & Vehicle Engineering, 2022, 60(6): 105–110. DOI: 10.3969/j.issn.1673-3142.2022.06.024.
[14]	司戈, 王青松. 锂离子电池火灾危险性及相关研究进展 [J]. 消防科学与技术, 2012, 31(9): 994–996. DOI: 10.3969/j.issn.1009-0029.2012.09.029. SI G, WANG Q S. Fire risk of lithium-ion battery and related study progress [J]. Fire Science and Technology, 2012, 31(9): 994–996. DOI: 10.3969/j.issn.1009-0029.2012.09.029.
[15]	朱瑞卿, 胡玲玲, 周名哲. 锂电池多次冲击下的失效模式及损伤机制 [J]. 固体力学学报, 2023, 44(6): 795–804. DOI: 10.19636/j.cnki.cjsm42-1250/o3.2023.032. ZHU R Q, HU L L, ZHOU M Z. Failure modes and damage mechanisms of lithium-ion batteries under repeated impacts [J]. Chinese Journal of Solid Mechanics, 2023, 44(6): 795–804. DOI: 10.19636/j.cnki.cjsm42-1250/o3.2023.032.
[16]	PASTOR-FERNÁNDEZ C, UDDIN K, CHOUCHELAMANE G H, et al. A comparison between electrochemical impedance spectroscopy and incremental capacity-differential voltage as Li-ion diagnostic techniques to identify and quantify the effects of degradation modes within battery management systems [J]. Journal of Power Sources, 2017, 360: 301–318. DOI: 10.1016/j.jpowsour.2017.03.042.
[17]	MEDDINGS N, HEINRICH M, OVERNEY F, et al. Application of electrochemical impedance spectroscopy to commercial Li-ion cells: a review [J]. Journal of Power Sources, 2020, 480: 228742. DOI: 10.1016/j.jpowsour.2020.228742.
[18]	ZHU X Q, WANG H, ALLU S, et al. Investigation on capacity loss mechanisms of lithium-ion pouch cells under mechanical indentation conditions [J]. Journal of Power Sources, 2020, 465: 228314. DOI: 10.1016/j.jpowsour.2020.228314.
[19]	ZHU X Q, WANG Z P, WANG C, et al. Overcharge investigation of large format lithium-ion pouch cells with Li(Ni_0.6Co_0.2Mn_0.2)O₂ cathode for electric vehicles: degradation and failure mechanisms [J]. Journal of the Electrochemical Society, 2018, 165(16): A3613–A3629. DOI: 10.1149/2.0161816jes.
[20]	LI J, MURPHY E, WINNICK J, et al. Studies on the cycle life of commercial lithium ion batteries during rapid charge-discharge cycling [J]. Journal of Power Sources, 2001, 102(1/2): 294–301. DOI: 10.1016/S0378-7753(01)00821-7.
[21]	MÜLLER V, SCURTU R G, MEMM M, et al. Study of the influence of mechanical pressure on the performance and aging of lithium-ion battery cells [J]. Journal of Power Sources, 2019, 440: 227148. DOI: 10.1016/j.jpowsour.2019.227148.
[22]	BARAI A, TANGIRALA R, UDDIN K, et al. The effect of external compressive loads on the cycle lifetime of lithium-ion pouch cells [J]. Journal of Energy Storage, 2017, 13: 211–219. DOI: 10.1016/j.est.2017.07.021.
[23]	FERG E, ROSSOUW C, LOYSON P. The testing of batteries linked to supercapacitors with electrochemical impedance spectroscopy: a comparison between Li-ion and valve regulated lead acid batteries [J]. Journal of Power Sources, 2013, 226: 299–305. DOI: 10.1016/j.jpowsour.2012.10.087.
[24]	PFRANG A, KERSYS A, KRISTON A, et al. Long-term cycling induced jelly roll deformation in commercial 18650 cells [J]. Journal of Power Sources, 2018, 392: 168–175. DOI: 10.1016/j.jpowsour.2018.03.065.